|
オガワ タクミ
Ogawa Takumi
小川 匠 所属 鶴見大学 歯学部 歯学科 クラウンブリッジ補綴学 鶴見大学 歯学部 鶴見大学 歯学部 歯学科 歯科医学教育学 職種 教授 |
|
| 論文種別 | 【査読あり】 研究論文（学術雑誌） |
| 言語種別 | 英語 |
| 査読の有無 | 査読あり |
| 表題 | Influence of filler on bite impression material in transillumination method for occlusal examination |
| 掲載誌名 | 正式名：DENTAL MATERIALS JOURNAL ISSNコード：02874547 |
| 出版社 | JAPANESE SOC DENTAL MATERIALS DEVICES |
| 巻・号・頁 | 32(1),pp.144-149 |
| 著者・共著者 | Takuya Kihara,Yuko Shigeta,Rio Hirabayashi,Tomoko Ikawa,Eriko Ando,Shinya Hirai,Hiroki Nikawa,Takumi Ogawa |
| 発行年月 | 2013/01 |
| 概要 | The purpose of this present study was to investigate the influence of material filler and RGB values' fluctuation on creating a calibration curve, which indicates the relationship between material thickness and transmitted light brightness using the transillumination method. Creating the calibration curves were carried out through the following three methods; 1) the conventional method creates the calibration curve with a formula of thickness, 2) the maximum value method, with samples of a specified thickness, and 3) the actual value method, with a microscope. Furthermore, the reliability of each curve was verified via scanned artificial tooth data. In addition, the characteristics of light decrement were investigated. From our results, it was suggested that the filler diameter must be considered when the calibration curve is created using the bite impression material with a filler. In addition, it was suggested that the RGB values' fluctuation did not influence the calibration curve. |
| DOI | 10.4012/dmj.2012-165 |
| PMID | 23370883 |